GX 470 V8-4.7L (2UZ-FE) (2004)
a. Place the front seal plate on the coil assembly.
b. Place the brush holder on the coil assembly with the pin facing upward.
NOTE: Be careful of the holder installation direction.
c. Install the 2 screws.
Torque: 1.8 Nm (18 kgf.cm, 16 in.lbf)
d. Align the pins of the brush holder with the holes of the rear seal plate, and install the rear seal plate.
18. INSTALL GENERATOR REAR END COVER
a. Install the terminal insulator.
NOTE: Be careful of the terminal insulator installation direction.