GX 470 V8-4.7L (2UZ-FE) (2004)
30.
Install the front stabilizer link assembly LH with the 2 nuts.
Torque: 70 N.m (710 kgf.cm, 52 ft.lbf)
NOTE:
If the front stabilizer link ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
31.
Install the front stabilizer link assembly RH with the 2 nuts.
Torque: 70 N.m (710 kgf.cm, 52 ft.lbf)
32.
Connect the steering gear outlet return tube.
A.
Using the 17 mm Union nut wrench (or equivalent), connect the outlet return tube.
Torque: 44 N.m (440 kgf.cm, 32 ft.lbf)
HINT:
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
^
This torque wrench should be held as shown in the illustration.
B.
Install the hose with the clip.
33.
Connect the pressure feed tube assembly.