GX 470 V8-4.7L (2UZ-FE) (2004)
Torque: 9.5 Nm (97 kgf-cm, 84 inch lbs.)
b. Install the rear stabilizer control cylinder with the bolt and nut.
Torque: 130 Nm (1,326 kgf-cm, 96 ft. lbs.)
NOTICE: Do not hold or install the rear stabilizer control cylinder by the cylinder boot.
14. CONNECT REAR STABILIZER CONTROL TUBE NO.2
a. Install the rear stabilizer control tube No.2 to the rear stabilizer control cylinder with the 2 union bolts and 2 new pressure port gaskets.
Torque: 69 Nm (704 kgf-cm, 51 ft. lbs.)
NOTICE: Insert the stopper of the rear stabilizer control tube No.2 into the rear stabilizer control cylinder.
15. BLEED SUSPENSION FLUID
SST 09760-60010
16. CHECK FOR FLUID LEAKS
17. CONNECT STABILIZER BAR FRONT
a. Support the stabilizer bar front with a jack. Place a wooden block between the jack and the stabilizer bar front to prevent damage.
HINT: Place the jack under the left side of the vehicle.