GX 470 V8-4.7L (2UZ-FE) (2004)
d. Using a socket hexagon wrench (8 mm), install the stabilizer bar rear with the 4 bolts and 2 rear stabilizer brackets lower.
Torque: 50 Nm (510 kgf-cm, 37 ft. lbs.)
1. Check that the protrusions on the stabilizer bushes rear are positioned within 20° of the identification marks.
19. STABILIZE SUSPENSION
a. Lower the vehicle.
1. Place the 4 wheels on the ground with the SST connected.
NOTICE:
^ Pay attention to the SST while lowering the vehicle.
^ Ensure that the jack and lift are completely separated from the vehicle.
b. Set charging pressure to within the specified range.
1. Charge suspension fluid with the SST
Specified charging pressure:
2.60 to 3.00 MPa at 20°C (68°F) (Fluid temperature)
2.90 to 3.40 MPa at 35°C (95°F) (Fluid temperature)
c. Stabilize the vehicle.
1. Do not perform any operations on the vehicle for 30 seconds or more after charging suspension fluid. The vehicle will stabilize during this
time.
20. CHECK SUSPENSION FLUID PRESSURE
a. Check the suspension fluid pressure.
21. MEASURE VEHICLE HEIGHT
Refer to Alignment; Service and Repair.
22. INSTALL ENGINE UNDER COVER SUB-ASSY NO.1
23. INSTALL SPARE DISC WHEEL
24. INSTALL STEP SUB-ASSY LH
25. INSTALL BATTERY
26. INSTALL RADIATOR SUPPORT SEAL UPPER