GX 470 V8-4.7L (2UZ-FE) (2004)
Acceleration Sensor: Service and Repair
Kinetic Dynamic Suspension System
ACCELERATION SENSOR ASSY (KDSS)
REPLACEMENT
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE RR CONSOLE BOX ASSY
HINT: Refer to the procedures up to "REMOVE RR CONSOLE BOX ASSY".
3. REMOVE ACCELERATION SENSOR ASSY
a. Disengage the 2 clamps.
b. Remove the 2 bolts and acceleration sensor assy.
c. Disconnect the connector from the acceleration sensor assy.
4. INSTALL ACCELERATION SENSOR ASSY
a. Connect the connector to the acceleration sensor assy.
b. Install the acceleration sensor assy with the 2 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
c. Engage the 2 clamps.
5. INSTALL RR CONSOLE BOX ASSY
NOTICE: When installing the rear console box assy, do not apply excessive force, as the bracket may become deformed.
6. CONNECT BATTERY NEGATIVE TERMINAL
7. PERFORM ACCELERATION SENSOR ASSY ZERO POINT CALIBRATION
Refer to Suspension Control ( Automatic - Electronic Level ); Testing and Inspection.