GX 470 V8-4.7L (2UZ-FE) (2004)
/Page-1188003.png)
4. DRAIN SUSPENSION FLUID
a. Loosen the bleeder plug on the stabilizer control w/ accumulator housing assy and drain suspension fluid.
HINT:
^
Drain suspension fluid when performing the operations related to the hydraulic circuits.
^
Draining suspension fluid decreases suspension fluid pressure.
b. Tighten the bleeder plug.
Torque: 9.5 Nm (97 kgf-cm, 84 inch lbs.)
5. REMOVE ENGINE UNDER COVER SUB-ASSY NO.1
6. SEPARATE STABILIZER BAR FRONT
7. REMOVE SPARE DISC WHEEL
8. SEPARATE STABILIZER BAR REAR
9. REMOVE FRONT DISC WHEEL
10. REMOVE FRONT STABILIZER CONTROL TUBE NO.1 AND NO.2
a. Remove the 2 bolts and front stabilizer tube protector.
b. Using SST, disconnect the front stabilizer control tube No.1 and No.2.
SST 09023-12700
c. Remove the 4 bolts and front stabilizer control tube No. 1 and No.2.
NOTICE:
^
Do not bend the control tubes.
^
Do not damage the control tubes and flare nuts.
