GX 470 V8-4.7L (2UZ-FE) (2004)
6. DISCONNECT HEIGHT CONTROL TUBE NO.2
a. Remove the holder.
b. Spread the clip and slowly pull the height control tube No.2 straight out.
NOTICE: Do not remove the clip from the union except when replacing it.
c. Remove the 2 O-rings.
7. REMOVE HEIGHT CONTROL COMPRESSOR ASSY
a. Disconnect the connector.
b. Remove the 3 clamps.
c. Remove the 3 bolts.
d. Disconnect the clip and remove the No. 1 hose.
e. Remove the 3 bolts, the height control compressor and the dryer with the bracket.
f.
Remove the bolt, the dryer and the O-ring.
g. Remove the 3 bushings from the height control compressor assy.
8. INSTALL HEIGHT CONTROL COMPRESSOR ASSY
a. Install the 3 bushings to the height control compressor assy.
b. Install the bolt, the dryer and the new O-ring.
Torque: 6.4 Nm (65 kgf-cm, 57 inch lbs.)
c. Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the