GX 470 V8-4.7L (2UZ-FE) (2004)
/Page-787001.png)
Shift Cable: Service and Repair
REPLACEMENT
1. SEPARATE BATTERY NEGATIVE TERMINAL
2. REMOVE SHIFT LEVER KNOB SUB-ASSY
3. REMOVE FLOOR SHIFT SHIFT LEVER KNOB SUB-ASSY
4. REMOVE CONSOLE UPPER PANEL GARNISH NO.1
5. REMOVE CONSOLE UPPER PANEL GARNISH NO.2
6. REMOVE CONSOLE PANEL UPPER
7. REMOVE CONSOLE PANEL UPPER REAR
8. SEPARATE TRANSMISSION CONTROL CABLE ASSY
a. Remove the nut and clip, separate the transmission control cable assy from the transmission control cable bracket.
b. Remove clip, separate the transmission control cable assy from the floor shift lever assy.
HINT: When the transmission control cable end is pressed, it can be removed from the floor shift lever.
NOTICE: The nut may be loosened (up to approximately 1 mm), however, never remove it.
9. REMOVE TRANSMISSION CONTROL CABLE ASSY
a. Remove the 4 nuts and pull out the transmission control cable assy.
10. INSTALL TRANSMISSION CONTROL CABLE ASSY
