GX 470 V8-4.7L (2UZ-FE) (2004)
b. Using a brass bar and a hammer, slightly tap in the spider bearing outer races.
c. Using 2 screwdrivers, remove the 4 snap rings from the grooves.
d. Using SST, push out the spider bearing from the propeller shaft.
SST 09332-25010
HINT: Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.
e. Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.
HINT: Remove the bearing on opposite side in the same procedure.
NOTICE: Do not tap the shaft.
f.
Install the 2 removed spider bearing outer race to the spider.
g. Using SST, push out the bearing from the yoke.
SST 09332-25010
HINT: Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.