GX 470 V8-4.7L (2UZ-FE) (2004)
j.
Install the 4 new snap rings of equal thickness which will allow no axial play.
HINT: Do not reuse the snap rings.
Thickness of snap ring
NOTICE:
^
Must use a new retainer ring.
^
Must use retainer rings of the same thickness as possible on both ends.
k. Using a plastic hammer, tap the yoke until there is no clearance between the bearing outer race and snap ring.
HINT: Install a new spider bearing on the sleeve side in the procedure described above.
8. INSTALL REAR PROPELLER SHAFT SLIDING SHAFT DUST COVER SUB-ASSY