GX 470 V8-4.7L (2UZ-FE) (2004)
/Page-817003.png)
a. Using SST, remove the front drive shaft assy LH.
SST 09520-01010, 09520-24010 (09520-32040)
NOTICE: Be careful not to damage the oil seal.
8. REMOVE FRONT DRIVE SHAFT ASSY RH
HINT: Remove the RH side by the same procedures with LH side.
SST 09520-01010, 09520-24010 (09520-32040)
9. INSPECT FRONT DRIVE SHAFT ASSY LH
a. Check to see that there is no remarkable play in the outboard joint.
b. Check to see that the inboard joint slides smoothly in the thrust direction.
c. Check to see that there is no remarkable play in the radial direction of the inboard joint.
d. Check the boots for damage.
NOTICE: Move the drive shaft assy keeping it level.
10. SEPARATE FRONT AXLE INBOARD JOINT BOOT CLAMP
a. Using a screwdriver, disclamp the inboard joint boot clamp.
b. Using the same manner to the inboard joint small boot clamp.
11. SEPARATE INBOARD JOINT BOOT
12. REMOVE FRONT DRIVE INBOARD JOINT ASSY LH
