GX 470 V8-4.7L (2UZ-FE) (2004)
a. Using SST and a press, install a new dust cover.
SST 09527-10011
20. INSTALL FRONT DRIVE INNER SHAFT OUTER SHAFT SNAP RING
a. Install a new snap ring.
21. INSTALL OUTBOARD JOINT BOOT
HINT: Before installing the boots, wrap the spline of the drive shaft with vinyl tape to prevent the boots from being damaged.
a. Temporarily install a new outboard joint boot with 2 clamps to the drive shaft.
b. Pack the outboard joint assy and boot with grease in the boot kit.
Grease capacity: 260 - 270 grams (9.2 - 9.5 ounces)
22. INSTALL FRONT AXLE OUTBOARD JOINT BOOT CLAMP
a. Mount drive shaft in a soft vise.
b. Secure the outboard joint boot clamps onto the boot.
c. Place SST onto the outboard joint large boot clamp.
SST 09240-00020, 09521-24010
Clearance: 0.8 mm (0.031 inch) or less
d. Tighten the SST so that the large clamp is pinched.
NOTICE: Do not overtighten the SST.
e. Using SST, adjust the clearance of the large clamp.
SST 09240-00020
Clearance: 0.8 mm (0.031 inch) or less
f.
Employ the same manner to the outboard joint small boot clamp.
23. INSTALL INBOARD JOINT BOOT