GX 470 V8-4.7L (2UZ-FE) (2004)
B.
Install the rear output shaft sub-assembly, front drive chain, and driven sprocket sub-assembly to the case rear.
HINT:
Check that the rear output shaft sub-assembly and driven sprocket sub-assembly turn lightly. If necessary, heat the rear case to about 122 - 176°F
(50 - 80°C).
C.
Using a snap ring expander, install the snap ring.
30.
Install the center differential lock fork sub-assembly w/front drive clutch sleeve.
A.
Install the center differential lock fork sub-assembly and front drive clutch sleeve.
B.
Install the bolt.
Torque: 24 N.m
(245 kgf.cm, 18 ft.lbf)
C.
Using a screwdriver and hammer, drive in the snap ring.
NOTE:
Make sure to install the fork and clutch sleeve in the correct direction.