HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
HINT
The illustration is for the RH side. The LH side is the opposite of the RH side.
4. REMOVE NO. 1 ULTRASONIC SENSOR BEZEL
(a) Disengage the 2 claws and remove the No. 1 ultrasonic sensor bezel from the rear bumper assembly.
HINT
The illustration is for the RH side. The LH side is the opposite of the RH side.
Installation
PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Rear Side): INSTALLATION
1. INSTALL NO. 1 ULTRASONIC SENSOR BEZEL
(a) Align the protrusions on the bumper hole with the slits of the No. 1 ultrasonic sensor bezel as shown in the illustration, and install the No. 1
ultrasonic sensor bezel.
HINT
The illustration is for the RH side. The protrusions on the LH side are the opposite of those on RH side.
2. INSTALL NO. 1 ULTRASONIC SENSOR
NOTICE:
Do not apply excessive force to the No. 1 ultrasonic sensor while performing the following procedure.
(a) Engage the claw to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor bezel.
HINT
The illustration is for the RH side. The LH side is the opposite of the RH side.
3. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
(a) Slide the No. 1 ultrasonic sensor retainer as shown in the illustration to install it.