HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RECEIVER
(a) Connect the connector to the tire pressure warning receiver.
(b) Engage the 2 tabs into the holes to temporarily install the tire pressure warning receiver.
(c) Install the bolt.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation
3. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH
HINT
Refer to the instructions for Installation of the rear seat side airbag assembly LH See: Restraint Systems/Air Bag Systems/Air
Bag/Service and Repair/Removal and Replacement/Rear Seat Side Airbag Assembly/Installation.
4. INSPECT TIRE PRESSURE WARNING SYSTEM
(a) Inspect the tire pressure warning system See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.