HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(a) Open the front luggage compartment trim cover and disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
4. REMOVE REAR SEAT ASSEMBLY
See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly/Removal
5. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
6. REMOVE REAR SEAT SIDE AIRBAG ASSEMBLY
CAUTION:
When storing the rear seat side airbag assembly, keep the airbag deployment side facing upward.
(a) Check that the power switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the airbag connector from the rear seat side airbag assembly.
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
(1) Slide the slider to release the lock, and then disconnect the yellow airbag connector.
Text in Illustration