IS 250 AWD V6-2.5L (4GR-FSE) (2006)
/Page-1831003.png)
d. Place the reflector.
1. Hang the string (with weight) from the center of the vehicle's rear emblem. Mark the vehicle's rear center point on the ground. Repeat the
same procedure for the front of the vehicle.
2. Set one end of the 10m (32.82 ft) string on the vehicle's rear center point. Run the string over the vehicle's front center point to a position 5
m (16.41 ft) beyond the vehicle front center point, as shown in the illustration. Mark the 5m (16.41 ft) position.
3. Using a tape measure, measure 12mm (0.47 in.) to the left of the 5 m (16.41 ft) position. Place the reflector at that position.
NOTE: Perform the operation as precisely as possible.
e. Adjust the radar beam axis.
