IS 250 AWD V6-2.5L (4GR-FSE) (2006)
/Page-1961020.png)
5. INSTALL NO. 1 ROOF WIRE (w/o Sliding Roof)
a. Install the roof wire.
1. Remove the peeling paper from one side of double-sided tape.
2. Attach double-sided tape to the marks on the roof headlining, as shown in the illustrations below above.
3. Remove peeling paper from the other side of double-sided tape.
4. Align the wire harness to double-sided tape. Also, align the marking tape areas of the wire harness to the marks on the roof headlining.
Temporarily attach the wire harness to the roof headlining. Secure the wire harness to the roof headlining with vinyl tape.
NOTICE: Securely install the No. 1 roof wire. If the wire is not secure, noise will occur.
6. INSTALL NO. 1 ROOF WIRE (w/ Sliding Roof)
a. Install the roof wire.
