IS 250 AWD V6-2.5L (4GR-FSE) (2006)
INSPECTION
1. INSPECT REAR SPEED SENSOR
a. Inspect the rear speed sensor. If any of these occur, replace the rear speed sensor with a new one:
^
The surface of the rear speed sensor is cracked, dented, or chipped off.
^
The connector or wire harness is scratched, cracked, or damaged.
^
The rear speed sensor has been dropped.
INSTALLATION
1. INSTALL REAR SPEED SENSOR
a. Install the rear speed sensor with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 inch lbs.)
NOTICE: Prevent foreign matter from attaching to the sensor tip.
b. Connect the speed sensor connector.
2. INSTALL REAR WHEEL
a. Install the rear wheel.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
3. INSPECT SPEED SENSOR SIGNAL