IS 250 AWD V6-2.5L (4GR-FSE) (2006)
6. Check that the master caution indicator light blinks and VSC TEST MODE is displayed on the multi information display (Test Mode).
HINT:
^ If the master caution indicator light does not blink and/or VSC TEST MODE is not displayed on the multi information display, perform
zero point calibration again.
^ The zero point calibration is performed only once after the system enters the Test Mode.
^ Calibration cannot be performed again until the stored data is cleared once.
7. Turn the engine switch off and disconnect the SST from the DLC3.