IS 250 AWD V6-2.5L (4GR-FSE) (2006)
d. Check that oil is drained from the oil filter. Then disconnect the pipe and remove the O-ring, as shown in the illustration.
e. Using SST, remove the oil filter cap.
SST 09228-06501
f.
Remove the oil filter element and O-ring from the oil filter cap.
NOTICE: Be sure to remove the O-ring (for the cap) by hand, without using any tools, to prevent damage to the groove for the O-ring on the
cap.
4. INSTALL OIL FILTER ELEMENT
a. Clean the inside of the oil filter cap, the threads and O-ring groove.
b. Apply a small amount of engine oil to a new O-ring and install it to the oil filter.
c. Set a new oil filter element to the oil filter cap.
d. Remove any dirt or foreign matter from the installation surface of the engine.
e. Apply a small amount of engine oil to the O-ring again and install the oil filter cap.