IS 250 AWD V6-2.5L (4GR-FSE) (2006)
Disassembly
1.
Disconnect the cable from the negative (-) battery terminal.
2.
Remove the cool air intake duct seal by removing the 11 clips.
3.
Remove the engine compartment side cover LH by removing the 5 clips.
4.
Remove the engine compartment side cover RH by removing the 2 clips.
5.
Remove the V-bank cover sub-assembly.
A.
Raise the V-bank cover to disengage the clip on the rear of the cover.
B.
Raise the cover again to disengage the 2 clips on the front of the cover and remove the cover.
NOTE:
Attempting to disengage both front and rear clips at the same time may cause the cover to break.
6.
Discharge the fuel system pressure.
FUEL SYSTEM CAUTIONS: