IS 250 AWD V6-2.5L (4GR-FSE) (2006)
C.
Connect the MAF connector and clamp to the air cleaner.
26.
Connect the No. 2 ventilation hose to the cylinder head cover with the clamp.
27.
Install the No. 1 air cleaner inlet with the 2 bolts.
Torque: 5.0 N*m (51 kgf*cm, 44 in*lbf)
28.
Connect the cable to the negative (-) battery terminal.
Torque: 5.4 N*m (55 kgf*cm, 48 in*lbf)
29.
Check for fuel leaks.
A.
Connect TIS Techstream to DLC3.
NOTE
Switch OFF all accessories and A/C before connecting TIS Techstream.
B.
Turn the engine switch ON (IG). Do NOT start the engine.
C.
Enter the following menus:
Powertrain / Engine / Active Test / FUEL PUMP / SPD.
D.
Check for fuel leaks.
Check that there are NO fuel leaks anywhere in the system. If there is a fuel leak, repair or replace parts as necessary.
30.
Check for engine oil leaks.
31.
Check the ignition timing.
A.
Warm up the engine and then stop the engine.