IS 250 AWD V6-2.5L (4GR-FSE) (2006)
Cabin Temperature Sensor / Switch: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
2. REMOVE FRONT DOOR SCUFF PLATE LH (w/o Illumination)
3. REMOVE FRONT DOOR SCUFF PLATE LH (w/ Illumination)
4. REMOVE FRONT DOOR OPENING TRIM COVER LH
5. REMOVE SIDE INSTRUMENT PANEL LH
6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
8. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
9. REMOVE ROOM TEMPERATURE SENSOR
a. Disconnect the connector and air hose.
b. Detach the claw and remove the sensor.
INSTALLATION
1. INSTALL ROOM TEMPERATURE SENSOR
a. Install the sensor with the claw.
b. Connect the connector and attach the air hose.
2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY