IS 250 AWD V6-2.5L (4GR-FSE) (2006)
Fog/Driving Lamp: Adjustments
ADJUSTMENT
1. VEHICLE PREPARATION FOR FOG LIGHT AIM
a. Prepare the vehicle:
-
Ensure there is no damage or deformation to the body around the fog lights.
-
Fill the fuel tank.
-
Make sure that the oil is filled to the specified level.
-
Make sure that the coolant is filled to the specified level.
-
Inflate the tires to the appropriate pressure.
-
Place the spare tire, tools, and jack in their original positions.
-
Unload the trunk.
-
Sit a person of average weight (68 kg, 150 lb) in the driver's seat.
2. PREPARATION FOR FOG LIGHT AIMING
a. Prepare the vehicle according to the conditions:
-
Place the vehicle in a location that is dark enough to clearly observe the cutoff line. The cutoff line is a distinct line, which light from the
fog lights can be observed and which it cannot.
-
Place the vehicle at a 90 degree angle to the wall.
-
Create a 7.62 m (25 ft) distance between the vehicle (fog light bulb center) and the wall.
-
Place the vehicle on a level surface.
-
Bounce the vehicle up and down to settle the suspension.
NOTE: A distance of 7.62 m (25 ft) between the vehicle (fog light bulb center) and the wall is necessary for proper aim adjustment. If
unavailable, secure a distance of exactly 3 m (9. 84 ft) for check and adjustment. (The target zone will change with the distance, so follow
the instructions in the illustration.)
b. Prepare a piece of thick white paper (approximately 2 m (6. 6 ft) (height) x 4 m (13.1 ft) (width)) to use as a screen.
c. Draw a vertical line down the center of screen (V line).