IS 250 AWD V6-2.5L (4GR-FSE) (2006)
/Page-1062003.png)
a. Disconnect the 4 connectors from the injector driver.
b. Remove the bolt, 2 nuts and injector driver.
NOTE: Be careful not to drop or strike the injector driver.
INSTALLATION
1. INSTALL INJECTOR DRIVER
a. Install the injector driver with the bolt and 2 nuts.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
NOTE:
-
Be careful not to drop or strike the injector driver.
-
The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas
of the injector driver and engine before installing the injector driver.
b. Connect the 4 connectors to the injector driver.
2. INSTALL NO. 1 ENGINE COVER
3. INSTALL NO. 1 INLET AIR CLEANER
