IS 250 AWD V6-2.5L (4GR-FSE) (2006)
/Page-1141005.png)
8. Install the Authorized Modifications Label.
A. Using a permanent marker enter the following information on the label:
^
ECM part number [Refer to the Parts Information section for the CURRENT PART NUMBER]
^
Calibration ID(s) [Refer to the Calibration Identification Chart for the NEW CALIBRATION ID]
^
Dealer Code
^
Repair Date
^
Change Authority [This TSIB number]
B. Affix the Authorized Modifications Label to the vehicle at the location shown in Figure 3. The Authorized Modifications Label is available
through the MDC P/N 00451-OOOO1-LBL.
9. Start the engine and warm it up to normal operating temperature before test driving.
10. Test drive the vehicle to confirm proper vehicle operation.
