IS 250 AWD V6-2.5L (4GR-FSE) (2006)
Air Bag: Service and Repair
Driver Side Knee Airbag assembly
Removal & Installation
REMOVAL
1. PRECAUTION CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. REMOVE FRONT DOOR SCUFF PLATE (W/o Illumination)
4. REMOVE FRONT DOOR SCUFF PLATE (W/ Illumination)
5. REMOVE FRONT DOOR OPENING TRIM COVER
6. REMOVE INSTRUMENT SIDE PANEL
7. REMOVE NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
a. Remove the 4 bolts and driver side knee airbag assembly.
b. Disconnect the connector.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
INSTALLATION
1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
a. Connect the connector.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
b. Install the driver side knee airbag assembly with the 4 bolts.
Torque: 10.N.m (10. 2 kgf.cm, 7 ft.lbf)
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
3. INSTALL NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
4. INSTALL INSTRUMENT SIDE PANEL