IS 250 AWD V6-2.5L (4GR-FSE) (2006)
a. Check the function of the SST.
b. Precaution.
c. Disconnect the cable from the negative battery terminal.
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
d. Remove the front passenger side knee airbag assembly.
e. Install the SST.
1. Connect the SST connector to the front passenger side knee airbag assembly.
SST 09082-00700, 09082-00770
NOTE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock.
2. Install the front passenger side knee airbag assembly.
NOTE: Take care not to damage the SST wire harness.
3. Move the SST at least 10.m (33 ft) away from the vehicle front side window.
4. Maintaining enough clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
NOTE: Take care not to damage the SST wire harness.
5. Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the battery negative (-) terminal.
f.
Deploy the airbag.
1. Check that no one is inside the vehicle or within a 10.m (33 ft) radius of the vehicle.
2. Press the SST activation switch and deploy the airbag.