IS 250 AWD V6-2.5L (4GR-FSE) (2006)
h. Dispose of the front passenger airbag assembly.
CAUTION:
-
The front passenger airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
-
Use gloves and safety glasses when handling a front passenger airbag assembly with a deployed airbag.
-
Do not apply water, etc. to a front passenger airbag assembly with a deployed airbag.
-
Always wash your hands with water after completing the operation.
1. Remove the front passenger airbag assembly from the tire.
2. Place the front passenger airbag assembly in a plastic bag, tie it tightly and dispose of it as other general part disposal.
Removal and Installation
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. REMOVE ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY".
4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
a. Disconnect the connector.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
b. Remove the 2 clips.
c. Remove the 9 bolts and curtain shield airbag assembly.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY