IS 250 AWD V6-2.5L (4GR-FSE) (2006)
e. Connect the connector.
2. INSTALL FRONT SEAT BELT RETRACTOR COVER
a. Engage the claw and install the front seat belt retractor cover to the body.
3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
a. Check the degree of tilt when the ELR begins to lock.
1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the
belt.
NOTE: Do not disassemble the retractor.
b. Temporarily install the front seat outer belt assembly with the 2 bolts.
c. Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.
Torque: For upper bolt 7.5 N.m(77 kgf c.m, 66 in.lbf)
For lower bolt 42 N.m(428 kgf.cm, 31 ft.lbf)