IS 250 AWD V6-2.5L (4GR-FSE) (2006)
/Page-1691004.png)
b. With the front passenger airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned,replace the
front passenger airbag assembly, instrument panel or instrument panel reinforcement with a new one:
-
Cuts, minute cracks or marked discoloration on the front passenger airbag assembly.
-
Cracks or other damage to the connectors.
-
Deformation or cracks on the instrument panel or instrument panel reinforcement.
CAUTION: Be sure to follow the correct removal and installation procedures.
Rear Airbag Sensor
ON-VEHICLE INSPECTION
1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
a. Perform a diagnostic system check
2. INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
a. Perform a diagnostic system check
b. When the quarter panel of the vehicle or its area is damaged, check if there is any damage to the rear airbag sensor. If there are any defects as
mentioned below, replace the rear airbag sensor with a new one:
-
Cracks, dents or chips on the sensor housing.
-
Cracks or other damage to the connector.
-
Peeling off of the label or damage to the serial number.
CAUTION: Be sure to following the correct removal and installation procedures.
3. INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
a. Replace the rear airbag sensor.
CAUTION: Be sure to following the correct removal and installation procedures.
HINT: The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag assembly has deployed.
Seat Position Sensor
ON-VEHICLE INSPECTION
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
a. Perform a diagnostic system check.
2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)
a. Perform a diagnostic system check.
b. Even if the airbag was not deployed, check if there is any damage to the seat position sensor.
If there are any defects as mentioned,replace the seat position sensor with a new one:
-
Cracks, dents or chips on the sensor housing.
-
Cracks or other damage to the connector.
