IS 250 AWD V6-2.5L (4GR-FSE) (2006)
1. Connect the red clip of the SST to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
HINT: At this time, do not connect the yellow connector that will later be connected to the seat belt pretensioner.
2. Press the SST deployment switch, and check that the LED of the SST deployment switch lights up.
CAUTION: If the LED is lit when the deployment switch is not pressed, the SST may be malfunctioning. Therefore, do not use the SST.
b. Connect SST.
1. Connect 2 SST, and then connect them to the front seat outer belt pretensioner.
SST 09082-00700, 09082-00770
NOTE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the pretensioner connector.
2. Place the outer belt on the ground and cover it with a tire and wheel assembly.
NOTE: Position the front seat outer belt assembly as shown in the illustration.