IS 250 AWD V6-2.5L (4GR-FSE) (2006)
7. CONNECT FRONT SEAT OUTER BELT ASSEMBLY
a. Install the floor end of the front seat outer belt assembly with the bolt.
Torque: 42 N.m (428 kgf.cm, 31 ft.lbf)
b. Check if the ELR locks.
NOTE: The check should be performed with the outer belt assembly installed
1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
8. INSTALL LAP BELT OUTER ANCHOR COVER
a. Engage the 3 claws to install the lap belt outer anchor cover.
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM INITIALIZATION
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.
11. INSPECT SRS WARNING LIGHT
Inspect the SRS warning light.
Rear Seat Inner Belt
REMOVAL
1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
2. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
a. Remove the bolt and the rear seat inner with center belt assembly LH.