IS 250 AWD V6-2.5L (4GR-FSE) (2006)
b. Remove the bolt and disconnect the floor end of the rear seat inner with center belt assembly RH.
c. Using a moulding remover, disengage the 4 claws and remove the rear seat shoulder belt cover LH.
HINT: Use the same procedures for the RH side and LH side.
d. Using a moulding remover, disengage the 4 claws and remove the rear seat shoulder belt cover center.
e. Disengage the 3 clips.
f.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
g. Remove the package tray trim panel assembly.