IS 250 AWD V6-2.5L (4GR-FSE) (2006)
Impact Sensor: Service and Repair
Side Airbag Sensor
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE FRONT DOOR SCUFF PLATE (W/ Illumination)
4. REMOVE FRONT DOOR SCUFF PLATE (W/o Illumination)
5. REMOVE REAR DOOR SCUFF PLATE
6. REMOVE CENTER LOWER PILLAR GARNISH
7. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY
a. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner
connector as shown in the illustration.
HINT: Tape the screwdriver tip before use.
b. Disconnect the connectors.
c. Remove the 2 bolts and separate the front seat outer belt assembly.