IS 250 AWD V6-2.5L (4GR-FSE) (2006)
^
Do not loosen the nut to align the holes for the cotter pin.
5. CONNECT FRONT SPEED SENSOR
a) Install the front speed sensor with the 3 bolts.
Torque: 6.0 Nm (61 kgf-cm, 4.4 ft. lbs.)
NOTICE: Do not twist the speed sensor front while installing.
b) Connect the front speed sensor connector.
6. CONNECT FRONT HEIGHT CONTROL SENSOR LINK ASSEMBLY
a) Install the front height control sensor link assembly to the front lower suspension arm with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 47.8 inch lbs.)
7. STABILIZE SUSPENSION
8. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
a) Fully tighten the nut on the lower side of the front shock absorber.
Torque: 112 Nm (1,140 kgf-cm, 82 ft. lbs.)
9. INSTALL ENGINE ROOM SIDE COVER
10. INSTALL FRONT TIRE
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
DISPOSAL
1. DISPOSE OF FRONT SHOCK ABSORBER