IS 250 AWD V6-2.5L (4GR-FSE) (2006)
a) Remove the 2 nuts and the No.2 differential support protector.
11. REMOVE REAR SUSPENSION MEMBER BRACE
a) Remove the 2 bolts and rear suspension member brace.
12. REMOVE REAR NO.2 SUSPENSION ARM
a) Loosen nut A.
NOTICE: Do not remove the nut.
b) Remove bolt B and the nut. Disconnect the stabilizer link assembly and height control sensor link bracket from the rear No.2 suspension arm
assembly.
c) Remove bolt C, nut, and rear shock absorber.
NOTICE: Turn the bolt while holding the nut.
d) Remove bolt D and the nut on the axle carrier side and remove the rear No.2 suspension arm assembly from the axle carrier.
NOTICE: Turn the bolt while holding the nut.
13. REMOVE REAR SHOCK ABSORBER WITH COIL SPRING