IS 250 AWD V6-2.5L (4GR-FSE) (2006)
If the resistance value is not as specified, replace the shift paddle switch.
INSTALLATION
1. INSTALL SHIFT PADDLE SWITCH
a) Install the 2 shift paddle switches and 2 brackets with the 4 screws.
Torque: 1.7 Nm (17 kgf-cm, 15 inch lbs.)
NOTICE: Make sure that the brackets are securely installed.
b) Connect the 2 switch wire connectors to the shift paddle switches.
c) Install the connector to the steering wheel assembly.
d) Install the clamp to the steering wheel assembly.
2. ADJUST SPIRAL CABLE SUB-ASSEMBLY
3. INSTALL STEERING WHEEL ASSEMBLY
4. INSTALL STEERING PAD
5. INSTALL LOWER NO.3 STEERING WHEEL COVER
6. INSTALL LOWER NO.2 STEERING WHEEL COVER
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION
Some systems need initialization after reconnecting the cable to the negative battery terminal.
9. INSPECT STEERING PAD
10. INSPECT SRS WARNING LIGHT