IS 250 AWD V6-2.5L (4GR-FSE) (2006)
a) Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.
b) Align the groove and the neutral alignment mark line.
c) Hold the switch in position and tighten the bolt.
Torque: 13 Nm (133 kgf-cm, 10 ft. lbs.)
d) After adjustment, perform the inspection.
INSTALLATION
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a) Install the park/neutral position switch to the manual valve shaft.
b) Temporarily install the bolt.
c) Install a new lock washer with the lock nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
d) Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the neutral position.
e) Remove the transmission control shaft lever.