IS 250 AWD V6-2.5L (4GR-FSE) (2006)
/Page-1200003.png)
7. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
a) Remove the 2 bolts, and disconnect the rear disc brake caliper assembly.
NOTICE: Use wire or equivalent to prevent the brake caliper from hanging down by the flexible hose.
b) Remove the No.1 caliper plates from the brake caliper.
8. REMOVE REAR DISC
9. SEPARATE NO.2 REAR UPPER CONTROL ARM ASSEMBLY
10. SEPARATE NO.1 REAR UPPER CONTROL ARM ASSEMBLY
11. SEPARATE NO.1 REAR SUSPENSION ARM ASSEMBLY
12. SEPARATE NO.2 REAR SUSPENSION ARM ASSEMBLY
13. SEPARATE REAR DRIVE SHAFT ASSEMBLY
a) Push the rear axle carrier toward the outside of the vehicle. Using a plastic hammer, separate the rear drive shaft assembly from the rear axle
carrier.
NOTICE:
^
Be careful not to damage the joint boot and speed sensor.
^
Do not push out the rear axle carrier excessively.
^
Use wire or equivalent to prevent the rear drive shaft assembly from hanging down.
14. REMOVE REAR DRIVE SHAFT ASSEMBLY
a) Using SST, remove the rear drive shaft assembly
SST 09520-01010, 09520-24010 (09520-32040)
NOTICE:
^
Be careful not to damage the oil seal, inboard joint boot and drive shaft dust cover.
^
Be careful not to drop the drive shaft assembly.
15. INSPECT REAR DRIVE SHAFT ASSEMBLY
INSPECTION
1. REMOVE REAR DRIVE SHAFT ASSEMBLY
