IS 250 AWD V6-2.5L (4GR-FSE) (2006)
b. Using a screwdriver, separate the windshield wiper No. 1 link rod from the pivot of the front wiper link assembly as shown in the illustration.
HINT: Tape the screwdriver tip before use.
c. Position the windshield wiper No. 1 link rod as shown in the illustration. Using a screwdriver, remove the windshield wiper No. 1 link rod.
HINT: Tape the screwdriver tip before use.
d. Using a "torx" socket wrench (T30), remove the 2 bolts and the windshield wiper motor assembly from the wind shield wiper link assembly.
INSTALLATION
1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
a. Using a "torx" socket wrench (T30), install the windshield wiper motor assembly with the 2 bolts.
Torque: 7.5 N.m (77 kgf.cm, 66 in.lbf)
b. Apply MP grease to the crank arm pivot of the windshield wiper motor assembly.