IS 250 AWD V6-2.5L (4GR-FSE) (2006)
d. Install the front wiper arm and blade assembly RH with the nut at the position as shown in the illustration.
Torque: 22 N.m (224 kgf.cm, 16 ft.lbf)
HINT: Hold the arm hinge by hand to fasten the nut.
e. Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and there is no
interference with the vehicle body.
6. INSTALL FRONT WIPER ARM HEAD CAP
a. Install the front wiper arm head cap.
HINT: Use the same procedures for the RH side and the LH side.
7. INSTALL ROOF DRIP SIDE FINISH MOULDING LH
8. INSTALL ROOF DRIP SIDE FINISH MOULDING RH
9. INSTALL FRONT UPPER FENDER PROTECTOR LH
a. Engage the claw and the 3 clips then install the front upper fender protector LH.
b. Engage the clip on the rubber portion of the cowl top ventilator louver sub-assembly to the front upper fender protector LH.
10. INSTALL FRONT UPPER FENDER PROTECTOR RH
HINT: Use the same procedures for the RH side and the LH side.
11. INSTALL ENGINE ROOM SIDE COVER LH
12. INSTALL ENGINE ROOM SIDE COVER RH
13. INSTALL COOL AIR INTAKE DUCT SEAL