IS 250 RWD V6-2.5L (4GR-FSE) (2007)
Parking Assist Distance Sensor: Service and Repair
REMOVAL
1. REMOVE COOL AIR INTAKE DUCT SEAL
2. REMOVE FRONT BUMPER ASSEMBLY
3. REMOVE NO.1 ULTRASONIC SENSOR
a. Disconnect the sensor connector.
b. Remove the sensor retainer as shown in the illustration.
c. Remove the No. 1 ultrasonic sensor from the front bumper.
4. REMOVE LUGGAGE COMPARTMENT TRIM COVER
5. REMOVE DECK SIDE TRIM BOX LH
6. REMOVE DECK SIDE TRIM BOX RH
7. REMOVE ROPE HOOK ASSEMBLY
8. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER
9. REMOVE ROOM LIGHT ASSEMBLY
10. REMOVE ROPE HOOK
11. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
12. REMOVE LUGGAGE COMPARTMENT TRIM HOOK
13. REMOVE SIDE LUGGAGE COMPARTMENT TRIM COVER
14. DISCONNECT LUGGAGE ROOM WIRE
15. REMOVE REAR BUMPER PLATE
16. REMOVE REAR BUMPER ASSEMBLY
17. REMOVE NO. 2 ULTRASONIC SENSOR
a. Disconnect the sensor connector.
b. Remove the sensor retainer as shown in the illustration.
c. Remove the No.2 ultrasonic sensor from the rear bumper.
18. REMOVE NO.1 ULTRASONIC SENSOR
a. Disconnect the sensor connector.