IS 250 RWD V6-2.5L (4GR-FSE) (2007)
2. REMOVE ENGINE ROOM SIDE COVER
3. REMOVE FRONT UPPER FENDER PROTECTOR
4. REMOVE HOOD SUPPORT ASSEMBLY
a. When the hood support assembly is to be replaced with a new one:
1. Using a screwdriver, remove the hood support assembly while releasing the 2 clips.
NOTICE: Remove the hood support assembly while supporting the hood with hand.
b. When the hood support assembly is to be reinstalled:
1. Remove the 3 bolts and hood support assembly.
NOTICE: Remove the hood support assembly while supporting the hood with hand.
INSTALLATION
NOTICE:
-
As much as possible avoid touching the stroke portions of the rod to prevent foreign matter from attaching to it. Be sure to hold the cylinders while
servicing.
-
Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.
-
Do not apply any load to the cylinders in the horizontal direction in order to prevent the rod from being deformed.
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. INSTALL HOOD SUPPORT ASSEMBLY
a. When a new hood support assembly is used:
1. Install a new hood support assembly.
NOTICE:
-
Install the hood support assembly while supporting the hood with hand.
-
Check that the hood support assembly is engaged in the ball joint and it cannot be pulled out.
b. When the removed hood support assembly is reused: