IS 250 RWD V6-2.5L (4GR-FSE) (2007)
/Page-1132004.png)
3. Using SST, connect terminals TS and CG of the DLC3.SST 09843-18040
4. Turn the engine switch on (IG).
5. Keep the vehicle stationary on a level surface for 2 seconds or more.
6. Check that the master caution indicator light blinks and "VSC TEST MODE" is displayed on the multi-information display (Test Mode).
HINT:
-
If the master caution indicator light does not blink and/or "VSC TEST MODE" is not displayed on the multi-information display,
perform zero point calibration again.
-
The zero point calibration is performed only once after the system enters the Test Mode.
-
Calibration cannot be performed again until the stored data is cleared once.
7. Turn the engine switch off and disconnect the SST from the DLC3.
Vehicle Stability Control System (W/ Vdim)
CALIBRATION
1. DESCRIPTION
-
After replacing the VSC relevant components or performing "Front wheel alignment adjustment", clear and read the sensor calibration data.
-
Follow the chart to perform calibration.
2. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION AND STORE SYSTEM INFORMATION (WHEN
