IS 250 RWD V6-2.5L (4GR-FSE) (2007)
3. Connect the intelligent tester to the DLC3.
4. Turn the engine switch on (IG).
5. Set the intelligent tester to Test Mode (select "TEST MODE").
HINT: Refer to the intelligent tester operator's for further details.
6. After the Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
7. Check that the master caution indicator light blinks and "VSC TEST MODE" is displayed on the multi-information display (Test Mode).
HINT:
-
If the master caution indicator light does not blink and/or "VSC TEST MODE" is not displayed on the multi-information display,
perform zero point calibration again.
-
The zero point calibration is performed only once after the system enters the Test Mode.
-
Calibration cannot be performed again until the stored data is cleared once.
8. Turn the engine switch off and disconnect the intelligent tester.