IS 250 RWD V6-2.5L (4GR-FSE) (2007)
INSTALLATION
1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
a. Install a new O-ring to the brake master cylinder sub-assembly.
b. Install the brake master cylinder sub-assembly to the booster assembly with the 2 nuts.
Torque: 12.5 Nm (127 kgf-cm, 9 ft. lbs.)
c. Install the brake actuator assembly to the actuator bracket with the 2 cap nuts.
Torque: 5.5 Nm (55 kgf-cm, 48 inch lbs.)
d. Using SST, connect the 2 brake lines to the brake master cylinder sub-assembly.
SST 09023-00101
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
e. Engage the clamp and connect the warning switch connector.
2. CONNECT CLUTCH RESERVOIR HOSE (for Manual Transmission)
a. Connect the clutch reservoir hose with the clamp.