IS 250 RWD V6-2.5L (4GR-FSE) (2007)
l.
Install the parking brake return with damper spring.
3. INSTALL PARKING BRAKE PEDAL ASSEMBLY (for 4WD)
a. Pass the No. 1 parking brake cable assembly through the parking brake pedal and hold the cable with the clip.
HINT: Fully tighten the No. 1 wire adjusting nut and lock nut when adjusting the parking brake pedal free play.
b. Fully bend the parking brake pedal claw.
c. Temporarily install the parking brake pedal by loosely tightening the 3 nuts.
d. Fully tighten the 3 nuts in the order shown in the illustration.
Torque: 13 Nm (133 kgf-cm, 10 ft. lbs.)
e. Connect the parking brake switch connector.
f.
Install the instrument panel junction block assembly with the 2 nuts.