IS 250 RWD V6-2.5L (4GR-FSE) (2007)
1. INSTALL YAW RATE AND ACCELERATION SENSOR
a. Install the yaw rate and acceleration sensor with the 2 bolts.
Torque:15 N.m (153 kgf.cm, 11 ft.lbf)
NOTE:
-
Do not damage the yaw rate and acceleration sensor.
-
Make sure that the yaw rate and acceleration sensor is installed securely.
b. Install the 2 wire harness clamps.
c. Connect the yaw rate and acceleration sensor connector.
2. INSTALL NO. 2 REAR AIR DUCT (for Automatic Transmission)
a. Install the No. 2 console box duct with the 2 clips.
3. INSTALL NO. 2 REAR AIR DUCT (for Manual Transmission)
a. Install the No. 2 console box duct with the clip.
4. INSTALL CONSOLE BOX
5. INSTALL CONSOLE BOX REGISTER ASSEMBLY
6. INSTALL FRONT ASH RECEPTACLE SUBASSEMBLY
7. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)
8. INSTALL FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)
9. INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)